Bessey K-Body Revo™ Clamp

The K Body® is a clamp designed to remain parallel when pressure is applied. The K-Body® is considered by manyto be the best parallel clamp in the industry for a variety of reasons. First, it is always at 90 degrees, and has a verylarge clamping surface. The K-Body® also has a glue resistant surface and enables a woodworker to achieve 1100 lbs of nominal clamping force. You can also use the K-Body® as a powerful spreader!

Bessey K-Body Cabinet Maker Package

KP Framing Blocks come with any of
the Cabinet Maker package. Buy any
one of these packs with the KP Blocks
and SAVE!

Bessey K-Body Clamps 4 Pack

Buy your K-Body Revo's in a convenient package
and SAVE!

The Bessey K Body REVO Variable Jaw is a replacement variable jaw offered as a single unit for the Vario K Body REVO

Pivoting jaw self aligns on tapered & irregular shaped materials, molded polyamide

• Pivoting jaws are packed in sets of 2
• KR-AS slides on and off of fixed and moveable jaws
• Perfect for holding materials that are irrregularly shaped
• Pivoitng jaws easily slide onto channels in fixed and stationary jaws, after removing standard jaw pads
• Pivoting jaws can used above and below rail and can be stacked for special applicatons

Rail protection pads snap onto rail and prevent clamped material from contacting steel rail

• Fits all Beesy K Body clamps
• Protects work material from accidental damage by contact with rail surface
• Rail protection pads are designed so that Besssey TK-6 clamps can be used to attach Bessey K Body REVO clamps to work surfaces
• molded polyamide

Ever have a project that requires an 80” long clamp? You don’t have to invest all that money on a clamp that you will only use once. If you already own Kbody ® clamps then this is a must have item for your workshop. The Extender will allow you to take any two K-body® clamps and turn them into one long clamp. Example: two 40” clamps will make one 80” clamp! Durable construction with no loss of strength or clamp parallelism. The Extender does not interfere with the top edge of the bar, allowing your stock to stay nice and flat during glue up. The K-body® Extender is perfect for large, oversized glue ups.

KP Framing blocks greatly simplify clamping set-up. Designed to hold clamps upright and at approximately 90° to each other, they increase stability and reduce frustration. For use with any size of K-Body or Cabinet Master clamps (not included), they facilitate quick, easy and square clamping for assemblies such as raised panel doors, cabinet carcasses, and drawers. The glue-resistant blocks are glass-fiber and can be screw-mounted to a work surface to create a gluing fixture.